Bonnet - Initial Fit

Its getting to the point where I need to see how the bonnet fits in relation to the scuttle and nosecone. 

Before fitting I attached the bonnet edging trim to both ends which simply knocks in with a rubber mallet (there is a thin bead of glue inside the trim to adhere to the bonnet edge).

I then offered the bonnet up to the scuttle and nosecone (this is temporarily fitted into position) and ratchet strapped front and aft to enable it to form to the shape. Initial indications seem ok - it is slightly proud along the front edges on both sides where the curve is not fully following the curvature of the nosecone . Fit to the scuttle seems good with no obvious area where it is sitting proud.

Clearly some fine tuning to be done and hopefully the gaping referred to above will resolve with the fitment of the bonnet catches and bonnet locating pins...